Відео

Stan! Where were you with this video when I built my first 2 chambers?! LOL! J/k Great advice, especially about the plywood on the inside. Seriously though, I wish I would have thought of that on my first kiln chamber. I have had to patch up a number of spots where I accidentally bumped the insulation with a piece of wood.

Fantastic video Stan!

thanks for the info... I'm assuming it would be the same checks for an L53.

keep em coming Stan!

Hello i need job in any country.

Nice

For the wet bulb water tank, how do you keep it from freezing in the winter when the kiln isn't running?

Great Video guys!

Phenomenal video guys! Very well done!

Pls the contact for Ur German dealership. Thx

Lots of checking on that lumber. Boards wont check past the sticker.

I have 2 L 200, I'm seeing things in your stacking and baffling that will not work in my kilms, your kills is something new, when I purchased mine I had to build my own chambers.

Be another happy Customer. Nathan Elliott sure brags about his on Out Of The Woods Sawmill & Kiln

Take the torch away from the tweaker enough black already

Nice shape

Damn that's fine

Hope y’all had a great show

That’s the Kiln at OTW proud owner Mr Nathan Elliot the founder and creator of Out Of The Woods Sawmill & Kiln now with over 170,000 worldwide followers on his UA-cam page

Why do the L200 screen values for dry and wet bulb not match the values in the manual for group 3 per your example?

Very inspiring… the power of a good idea and some dry wood!

Phenomenal video guys!

For installing The wet bulb and drive old I do not understand where the diagram leads connect

thank you Sir!

Good work guys!

How much foes the dryer cost?

At 2:25 you mention the signal wire that goes from slots 8 and 3 in the box to l200 controller. Is that wire included? If not, what gauge does it need to be?

When this was going up, what impressed me was the size of those doors!!!

Where’s the link for purchase?

AWESOME, Kiln, Out of the Woods Nathan Elliott is so awesome, thank you for partnering with him, super great guy.

How much is this system?

How can you help me building like that? Will it cost me much. I like your kiln dyer very much. Is it possible to power by solar? Thank you very much for the information and I wish you can help..

Nice setup.. how long does it take to dry a stack of this size?

i appreciate the lessons! i'm doing a woodwork course at this time and this fits right on, keep up the good work.

Can this fan/motor setup support reversing for change in airflow direction?

Thanks for these videos! I recently purchased a used L53 and I am building the kiln this spring. I did not receive owners manual and between your web site and these videos I am slowly putting my arms around what I need to do. Thanks again and please keep them coming. Oh maybe some videos on figuring drying schedules and the math behind it.

Saw straight and dry flat... words to live by!

Looking forward to you sharing all your knowledge... thank you!

Hello! Thank you for sharing your knowledge! Looking forward to learning more about the drying process!

Hence said the spacing is 30mm. But what about the orientation of the two pins in relation to the wood's grain, aren't they suppose to be tangential (parallel) to the grain of the wood?

What does the booster do? Is it a supplement to the heating element already in the L200M?

Thanks for this video. Your baffling looks much better than mine and simpler as well. I have learned something today in spite if myself!

At the 7:00 mark, the video shows the Wet Bulb set up. Can you do a short video to describe this rather unique reservoir system.

Thanks for the videos. Is that a stainless steel interior surface? --Kevin, L53 Owner

Do you have any video for explaining Nyle HT 54.